ASTM C773 PDF
Purchase your copy of ASTM C – 88() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Designation: C − 88 (Reapproved ) Standard Test Method for For referenced ASTM standards, visit the ASTM website, , or. Find the most up-to-date version of ASTM C at Engineering
|Published (Last):||16 September 2008|
|PDF File Size:||16.89 Mb|
|ePub File Size:||12.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
C 5 compressive strength of the specimen, psi or MPa; P 5 total load on cc773 specimen at failure, lbf or N; and A 5 calculated area of the bearing surface of the specimen, in.
ASTM C773 – 88(2016)
This test is a measure of the potential load-bearing usefulness of a ceramic. It is the responsibility of the user of this standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use.
The astn of all specimens shall be ground or lapped to yield plane and parallel faces. Place an appropriate guard around the specimen to contain flying fragments at failure; eye protection should be used by the operator.
The spherical surfaces shall be well lubricated, and the center of curvature shall lie on the lower face of the platen. Discard any pieces exhibiting cracks or flaws visible to the unaided eye. These faces shall be perpendicular.
A number in parentheses indicates the year of last reapproval. Enviado por Thamyres flag Denunciar. Suitable materials for cushion pads, selected in accordance with the compressive strength range of the material being tested, are shown in the following table: If the contact block is cracked during testing, it shall be replaced. NOTE 1—It is desirable to include details of the origin of the specimen and subsequent treatment.
ASTM International – Laboratory Directory – University of Dayton Research Institute
Single-operator component Between-laboratory component 1. Ideally, ceramics should be stressed this way in use.
Last previous edition C — 88 Current edition approved Sept. Originally published as C — 74 to replace C and C The compo- nents of variance for compressive strength results expressed as coefficients of variation were calculated as follows: They may be formed and matured for the purpose of compression testing, or they may be cut from matured whitew- are by sawing or coredrilling.
Precision and Bias 8.
One operator in each laboratory tested ten specimens of each material. New cushion pads shall be used for each specimen. C — 88 Reapproved Standard Test Method for Compressive Crushing Strength of Fired Whiteware Materials1 This standard is issued under the fixed designation C ; the number immediately following the designation indicates the ashm of original adoption or, in the case of revision, the year of last revision. Significance and Use 3.
A superscript epsilon e indicates an editorial change since the last revision or reapproval.